If you list products on our store, you must comply with all federal, state, and local laws and our policies applicable to those products and product listings, including this policy.
Toddler beds covered by this policy
A toddler bed is any bed that is sized to accommodate a full-size crib mattress that has minimum dimensions of 51 and 5/8 inches (1310 mm) in length and 27 and 1/4 inches (690 mm) in width, and is intended to provide free access and egress to a child who is not less than 15 months of age and weighs no more than 50 lb (27.7 kg).
Our policy for toddler beds
Amazon requires that all toddler beds have been tested to and comply with the specific regulation and standard requirements listed below:
CPSIA (Lead, Phthalates); and
16 CFR Part 1130 (Requirements for Consumer Registration of Durable Infant or Toddler Products); and
CPSA Section 14(a)(5) (Tracking Label); and
ASTM F1821-19e1 (Standard Consumer Safety Specification for Toddler Beds); or
16 CFR Part 1217 (Safety Standard for Toddler Beds)
We may request this information from you at any time, so we recommend that you have it easily accessible:
Your company name (if applicable) and seller ID
Your contact information: email address and phone number
A list of all toddler beds that you list
Images of the product and product packaging, as applicable, for all toddler beds that you list. Images must include all sides of the product and product packaging for our review
Product images or test report as evidence of compliance with registration card requirement (16 CFR Part 1130)
Product images or test report as evidence of compliance with mandatory tracking label requirements (CPSA Section 14(a)(5))
Product images or test report as evidence of compliance with warning and hazard label requirements (ASTM F1821-19e1 Sec. 8 or 16 CFR Part 1217), as applicable
Any product instructions and manuals for all toddler beds that you list
A Children’s Product Certificate (CPC) for all toddler beds, subject to this policy, that you list
Test reports from a CPSC-accepted lab confirming that each product was tested to and meets the regulations and standards listed above
Some labs provide special Amazon rates for testing. To find more information about these providers, go to the Service Provider Network.
How to submit information
If you receive a request from us for compliance documents, complete the
following steps to submit the requested information:
In Seller Central, select the Performance tab and choose
Under Manage your compliance in the bottom right corner, click
Product Compliance Requests.
To add compliance or appeal for a single product, click Add/Appeal
Compliance. To add compliance or appeal for multiple products, select each
product on the left hand side of the product and click Action Selected
Products at the top of the product requirement table to make a selection
about how you would like to submit documents and information.
Provide compliance documents and information in the Provide
Documents section, or provide appeal information and documents in the
Appeal Request section.
Click Submit for Approval to send your submission for review by
Note: Test reports must contain images of the tested
products that are sufficient to demonstrate that the product tested is the same as the
product listed on the detail page.
If you do not provide the required information by the applicable deadline, we may take the following actions:
Remove the relevant product listings
Suspend your ability to add new products, listing privileges, or both
Withhold any payments due to you
We reserve the right to take any further actions that may be necessary in our sole discretion.
Disclaimer: The information provided on this page does not, and is not intended to, constitute legal advice. All information, content, and materials available on this site are for general informational purposes only.